1. Turn the power off using the power button on the vacuum pod.
2. Unplug the vacuum.
3. Check for clogs in the hose or filter. Clear any clogs and wash filters if necessary.
4. Wait a minimum of 45 minutes for the vacuum to cool, then plug the vacuum in.
5. Turn the power switch on to start the vacuum.
This vacuum cleaner is equipped with a motor protective thermostat. If for some reason your vacuum overheats, the thermostat will automatically turn the suction motor off. Should this occur, perform the following steps to restart the thermostat:
1. Turn the unit off.
2. Unplug the vacuum.
3. Empty the dust cup and clean filters
4. Check for blockages in hose, accessories and inlet openings.
5. Allow the unit to cool for a minimum of 45 minutes.
6. Plug in the vacuum.
7. Restart the unit by turning the power on.
Note: If vacuum still does not start, contact Customer Service at: 0800 862 0453.
Make sure that the carpet height selector is not on the HARD FLOOR setting. If brush roll indicator light on the floor nozzle turns red, the brush roll has stopped spinning due to a blockage. Immediately turn off and unplug vacuum, disconnect the nozzle and remove blockage before reconnecting and turning vacuum back on. Pull the handle toward you and release the floor nozzle to disengage the auto-off feature.
Make sure the nozzle is flat against the floor and the handle is tilted back. Make sure the “Carpet” setting is engaged on the handle. If the red light is illuminated on the floor nozzle, see “How do I check for blockages?” Remove any excess hair that has wrapped around the brush roll. Carefully cut anything wound around the rotator brush with scissors. Avoid damaging or cutting the bristles. Check that the wand is fully engaged and making an electrical connection with the floor nozzle.
Pull up on the dust cup release latch and lift the dust cup off the pod.
With the dust cup removed, remove and rinse the foam and felt filters every 3 months. Let air dry completely before replacing. Hand wash only. Tap loose dirt off filters between washes as needed
The main body motor is 850 watts.
The dimensions of the Shark Rotator Powered Lift-Away Upright Vacuum cleaner are 117cm high x 31cm wide x 31cm deep.
First, remove the cord from the cord clip, then press the wand release button located near the top of the canister behind the wand. Gently pull up on the handle to remove the wand. Add the desired accessory to the end of the wand and begin cleaning. To replace, simply guide the wand behind the canister and press down until you hear a click.
The cord is 8 meters long.
The vacuum has a 1L dust cup capacity. It has an easy, bottom-empty design for quick removal of debris. The top also opens to remove stubborn debris.
The pod in lift-away mode weighs 2.5 kg
The upright weighs only 6.414 KG
All of our Shark Clean products have a 12 month warranty.
Our confidence in our design and quality control means that your new Shark vacuum cleaner is guaranteed for a total of 5 years*.
*12 months plus an extended warranty period of 4 years, subject to registration within 28 days of purchase when purchased from a retailer.
Our Steam Mops are covered by a 12 month guarantee, extendable to a total warranty period of 2 years (subject to registration).